Bm23 kegerator manual

This two product kegerator comes with a stainless steel 3" diameter double faucet draft tower. The gas hose, beer tubing, washers and clamps are included. You will need to specify your keg coupler set up and add a Co2 tank and regulator. The Beverage-Air BM23 is large enough to store both a full size keg (non- rubber) and up to a 10 lb. Co2 tank/5(6).  · The Beverage-Air BMB Commercial Kegerator holds a full size keg of beer and is equipped with a 3" insulated chrome single faucet draft beer tower. Beer Draft System Cost 20 Taps Installation Tiantai is the best chinese commercial beer brewing system company. We are commercial beer brewing system manufacturers and suppliers in various capacity. .  · just bought a superior kegerator from what I understand its the same as a BM what I need to know is what size is the hose for the tower cooler and the waste hose. The parts manual does not provide the sizes for them. Need ID/OD and length for both hoses.

Find genuine OEM Beverage Air BM23 replacement parts at Parts Town with the largest in-stock inventory and same day shipping until 9pm ET. Writing to ask for help with my beloved Beverage Air kegerator. I homebrew and would very much like to get it back in service. (And my wife would be thrilled to get my homebrew stuff out of the basement fridge!) BM Manual-Jim. Re: Requesting help with Beverage Air Kegerator BM buzzard86 # 10/01/11 PM. Joined: Sep TRUE Direct Draw Kegerator TDD I also have a Danby with the same problem. Apparently it is not the CO2 that is the problem. It is the fact that the temp. Get quality kegerator parts like instant read thermometers, drain pans, and refrigerator thermometers at Drip Tray Grid for BM23 Beverage Air Keg Refrigerator. Supplier of refrigerated.

I bought a Superior Kegerator (Beverage Air BM23) and the relay, over load, and wire to the evap fan was fried. I had a professional check it out and he determined that the compressor was fine and the other parts needed to be replaced. I called him again to see if he got the parts and never. just bought a superior kegerator from what I understand its the same as a BM what I need to know is what size is the hose for the tower cooler and the waste hose. The parts manual does not provide the sizes for them. Need ID/OD and length for both hoses. manual only talks about space temperature, and that the 5 setting should deliver degrees. Thats why I first was checking the temp inside the kegerator with a glass of water, and also with a dry gauge that also reads high/low. The high/low fluctuated +/- 7 degrees or so and seemed to indicate unit was operating correctly.