Ambrc decoder manual

Connection to a decoder is performed on the Network Setup page (7th Menu from top). E-Laps currently supports the following decoders: AMBrc Decoder, MYLAPS RC4 Decoder, AMBmx3 Decoder, TranX3 Decoder, ChipX Decoder and BIB Decoder. Supported connection method is TCP/IP, with Serial COM Port connection available soon. the AMBrc decoder. Try to find a position for the transponder free from the chassis, for instance on the front bumper and check for better readings from the decoder. Hits should be no less than 20 (at speed) and strength not lower than points. If no good horizontal position can be found, as a last resort. For installation details see your MYLAPS Onboard Display user manual. Recommended installation position: 1. MYLAPS Onboard Driver ID box – inside driver compartment 2. Switch – within reach of the driver/mechanic MYLAPS Onboard Display Driver ID box The MYLAPS Onboard Driver ID box is the device that communicates with your communicator.

The RC4 Decoder determines the exact time at which each transponder passes the detection loops. The decoder sends this data the timekeeper's computer. The decoder has a built-in practice mode that allows automated uploads of practice results to www.doorway.ru, without the need of a timekeeper. Please note all new RC4 Decoders come with Firmware The AMBrc System is designed for the timing and scoring of RC model car races. The (magnetic) signal of each car carrying an AMBrc transponder is picked up by the detection loop installed in the track surface. This loop is connected to the AMBrc decoder. The decoder timestamps the received transponder signals and sends this data to a connected. I am trying to hook up using a usb cable that hooks directly to the back of the ambrc decoder box ok I went and did a manual install and it finally worked now i am trying to get it to auto recognize the transponders but it wont. It will detect them in a transponder test though.

AMB i.t. B.V. Installation Manual AMBrc - Rev. b 9 second decoder for the speed and/or split time loop. Special designed software is necessary. For speed measurements the AMBrc decoder has to be set into speed-trap mode with the help of specially designed (AMB) software. The speed-trap mode is indicated on the. detection loop. The AMBrc decoder can not distinguish between transponder signals coming from the finish, speed or split time loop, permanent manual supervision is necessary in this case. For instance, when a car stops in between the two loops used for the speed trap for longer than the minimum lap time set in the software, the software. readings from the AMBrc decoder (in AMBrc mode only). If this is the case, try to find a transponder position free from the chassis, such as the front bumper, for better readings from the decoder. Hits should be no less than10+ (at speed) and strength +. For further information, see the system manual: Operating; Trouble shooting.