Konig satellite finder manual

Manual Konig Electronic SATFINDER (page 1 of 1) (English) Konig Electronic SATFINDER Zoom out Zoom in Page 1 SATFINDER USER GUIDE WIRING AND OPERATION: 1. Connect a jumper cable from the LNB to the Satellite Finder’s “TO LNB” input. 2. Connect the “TO REC” to V DC power which comes from the Satellite Receiver. 3. 1. Connect a jumper cable from the LNB to the Satellite Finder’s “TO LNB” input. 2. Connect the “TO REC” to V DC power which comes from the Satellite Receiver. 3. Make sure the Satellite Finder is properly connected. Plug in the AC cord and turn on the Satellite Receiver. There will be a Slight reading on the scale of around 1. 4. Allumez votre récepteur satellite. L’éclairage du cadran du SATFINDER doit s’allumer. Tournez le bouton de réglage de la sensibilité «5» vers la droite jusqu’à une petite butée de l’aiguille. Un signal sonore retentit en même temps. Le signal devient de plus en plus fort au fur et à.

The Konig SDFTA11 satellite receiver is suitable for the reception of free-to-air signals. The built-in motorpositioner (Usals), blind scan search mode and Diseqc // (for use with up to 16 LNB`s) can be used to receive thousands of channels of many satellites. \n\nThese channels can be stored and organized in 32 favourite lists. I connected my konig satellite finder and the signal was strong but still no signal. There was no strong wind yesterday only freezing cold weather, it's still cold today but the dish is in full sun and there is no ice on it. I looked at the manual tune and there is no signal at all. Ideas? grahamlthompson Distinguished Member. Jan 4, #2. I had borrowed a Konig Satellite Finder meter. Tomorrow I will get a CRL sat-finder which is similar. When you talk about using manual tune, I do not get a signal strength or quality reading on screen. You should get the read out if you select a transponder that carries one of the channels you can view.

Use this tool to align your satellite dish easily yourselfGet your own satellite finder at www.doorway.ruase subscribe and support our Yo. Satellite Finder, then reconnect the LNB/LNBF to your satellite receiver. Do not use the Satellite Finder directly in front of your satellite dish - this can result in a continuous full scale reading (ie. above ‘10’). If your LNB/LNBF has a gain higher than 60dB, insert a 5dB satellite attenuator between the LNB/LNBF and the Satellite Finder. 1. Connect a jumper cable from the LNB to the Satellite Finder’s “TO LNB” input. 2. Connect the “TO REC” to V DC power which comes from the Satellite Receiver. 3. Make sure the Satellite Finder is properly connected. Plug in the AC cord and turn on the Satellite Receiver. There will be a Slight reading on the scale of around 1. 4.